Mitsubishi Electric AE-C400 - Page 167

16. Initial settings - Basic settings/operation
167
WT09991X01
[1] Configuring interlocked LOSSNAY units
(1) Configuring interlocked LOSSNAY units
Note
• It is necessary for both the interlocked LOSSNAY and source indoor units to be configured. If either of
them are not configured, the addresses will not be registered and will return to an unset state.
(2) Configuring interlock source indoor units
Note
• It is necessary for both the interlocked LOSSNAY and source indoor units to be configured. If either of
them are not configured, the addresses will not be registered and will return to an unset state.
Step
1. Tap [Unit Settings] - [Interlocked LOSSNAY]
to display the Interlocked LOSSNAY Settings
screen.
2. Tap (A) to display (a).
3. Select the addresses of registered interlocked
LOSSNAY units from (a).
4. Tap [OK] in (a) to close (a).
5. Tap (B) to save the settings.
(B)
(A)
(a)
Step
1. Tap [Unit Settings] - [Interlocked LOSSNAY]
to display the Interlocked LOSSNAY Settings
screen.
2. Tap (A) to display (a).
3. Select the indoor unit address to be registered
from (a).
4. Tap [OK] in (a) to close (a).
5. Tap (B) to save the settings.
(B)
(A)
(a)
WT09991X01 英語IB詳細編 (3校 正式版).book 167 ページ ２０２４年７月３０日 火曜日 午後３時３４分