Mitsubishi Electric AE-C400 - Supplementary Information (Initial Settings); 17-1.Input Method for Peak Cut Control

17. Supplementary information (Initial settings)
198WT09991X01
17. Supplementary information
(Initial settings)
17-1. Input method for peak cut control
To use the peak cut control, power pulses or demand levels need to be input to the controller.
When the above inputs are made to other AE-C/EW-C controllers connected via LAN, their peak cut control
levels can be referenced.
(Input image)
Peak cut control method Remarks
1 External contact input A method in which control level
signals from the demand
controller are directly input to the
controller.
(Input image)
2 Modbus watt-hour meter A method in which the amount of
electric energy is directly input
from a Modbus (RS-485) watt-
hour meter to the controller.
(Input image)
3 PI controller input A method in which power pulses
are input to a PI controller and
the controller predicts the control
level.
(Input image)
External input adapter (option)
Demand controller
Demand level contact (max. 4 levels)
Watt-hour
meter
Watt-hour
meter
Electric energy amount
Watt-hour
meter
PI controller
Pulse detector
Power pulse count
This controller
Monitoring
Peak cut control system of other AE-C/EW-C (192.168.1.1)
Pulse detector
Watt-hour meter
WT09991X01 英語IB詳細編 (3校 正式版).book 198 ページ ２０２４年７月３０日 火曜日 午後３時３４分