16. Initial settings - Basic settings/operation
172
WT09991X01
16-2-8. Sub menu tab: PI Controller
Register PI controllers.
Tapping [Unit Settings] - [PI Controller] will display the PI Controller Settings screen.
Note
• Metering device names can be up to 20 characters in length. (Recommended name length is 12 characters
or less.)
However, the following characters cannot be used. < > & " '
Item Function and description
(A)
Target centralized
controller
Select the number of the AE-C/EW-C controller from the pull-down list.
(B) PI Controller address Select the addresses of PI controllers to be registered.
(C) Metering device name Configure the names of metering devices.
(D) Pulse Weight
Enter a pulse weight between 0.01 and 100.
Select a unit of measurement.
(E) [Save]/[Back]
After completing the setting, tap [Save].
To cancel the setting, tap [Back].
WT09991X01 英語IB詳細編 (3校 正式版).book 172 ページ ２０２４年７月３０日 火曜日 午後３時３４分
To Next Page
Loading...
