Mitsubishi Electric AE-C400 - Page 173

16. Initial settings - Basic settings/operation
173
WT09991X01
[1] Configuring PI controllers
Important
• Select a unit of measurement from [kWh], [m
3
], [MJ] and [--] (no unit).
• If not using a metering device, select [--] (no unit).
• When [--] (no unit) is selected, measured values will not be displayed as graph data for Energy Use Status.
Note
• Metering device names can be up to 20 characters in length. (Recommended name length is 12 characters
or less.)
However, the following characters cannot be used. < > & " '
Step
1. Tap [Unit Settings] - [PI Controller] to display
the PI Controller Settings screen.
2. Tap (A) to display (a).
3. Select the addresses of PI controllers to be
registered from (a).
4. Tap [OK] in (a) to close (a).
5. Tap (B) to input metering device names for
registered channels.
6. Tap (C) to input pulse values.
7. Select the pulse unit from the pull-down list in
(D).
8. Tap (E) to save the settings.
(A)
(B)
(a)
(E)
(C)
(D)
WT09991X01 英語IB詳細編 (3校 正式版).book 173 ページ ２０２４年７月３０日 火曜日 午後３時３４分