Mitsubishi Electric AE-C400 - Page 171

16. Initial settings - Basic settings/operation
171
WT09991X01
[1] Configuring energy management blocks
[2] Copying from block settings
Use this configuration to make block settings and energy block settings the same. After copying, configure
LOSSNAY with heater and humidifier if necessary.
Step
1. Tap [Unit Settings] - [Energy Management
Block] to display the Energy Management Block
Settings screen.
2. Tap (A) to input energy management block
names.
3. Tap (B) to display (a).
4. Select the block to be registered from (a).
5. Tap [OK] in (a) to close (a).
6. Tap (D) to save the settings.
Configure interlocked member LOSSNAY with
heater and humidifier by performing the following.
1. Tap (C) to display (a).
2. Select the unit address to be registered from (a).
3. Tap [OK] in (a) to close (a).
4. Tap (D) to save the settings.
(D)
(A)
(B)
(a)
(C)
Step
1. Tap [Unit Settings] - [Energy Management
Block] to display the Energy Management Block
Settings screen.
2. Tap (A) to display (a).
3. Tap [OK] in (a) to close (a).
4. Tap (B) to save the settings.
(B)
(a)
(A)
WT09991X01 英語IB詳細編 (3校 正式版).book 171 ページ ２０２４年７月３０日 火曜日 午後３時３４分