Mitsubishi Electric AE-C400 - Page 169

16. Initial settings - Basic settings/operation
169
WT09991X01
[1] Configuring blocks
Note
• Block names can be up to 20 characters in length.
However, the following characters cannot be used. < > & " '
[2] Copying from group settings
Step
1. Tap [Unit Settings] - [Block Settings] to
display the Block Settings screen.
2. Tap (A) to input block names.
3. Tap (B) to display (a).
4. Select the block to be registered from (a).
5. Tap [OK] in (a) to close (a).
6. Tap (C) to save the settings.
(B)
(a)
(A)
Step
1. Tap [Unit Settings] - [Block Settings] to
display the Block Settings screen.
2. Tap (A) to display (a).
3. Tap [OK] in (a) to close (a).
4. Tap (B) to save the settings.
(B)
(a)
(A)
WT09991X01 英語IB詳細編 (3校 正式版).book 169 ページ ２０２４年７月３０日 火曜日 午後３時３４分