1-3Features
1Overview
(4) Allows to operate the robot without learning robot language (sequencer direct performance)
● Allows to operate the robot without knowing robot language.
Allows you to operate the robot by writing predetermined setting value into the specified address in
shared memory. Therefore, this function can be fulfilled regardless of sequencer language (ladder, ST
language, SFC, etc.)
● Allows you to select either joint or linear interpolation. Also, allows you to adequately specify the robot
operations such as override, acceleration and deceleration, tool setting.
● Allows you to operate the robot with a sense, which is familiar to the sequencer programmer, to move a
positioning unit.
● Allows you to control the system operations only with sequencer.
Makes the program management easy so that a sequencer programmer can support for the change of
system specification and the problem.
● Allows you to control the system settings only with the sequencer in the GOT screen.
A sequencer programmer can support for the change of system specification and the problem so that the
program management gets so easy.
Command Action
Operation con-
trol
Mov Move for joint interpolation
Mvs Move for linear interpolation
Ovrd Specify the overall speed
Spd Specify the linear interpolation speed
Accel Specify the acceleration and deceleration speed
Definition com-
mand
Tool Specify the tool data
Hand command
Hopen/Hclose
Open/close a hand
To Next Page
Loading...
