Mitsubishi Electric MELSEC iQ-R RD78G4 - Page 119

4 ADVANCED SYNCHRONOUS CONTROL
4.3 Clutch
117
4
["5: Slippage method (Linear: Input value follow up)" is set.]
The output speed is changed depending on the input speed.
(When the input speed is decelerated and accelerated again, the speed might be accelerated rapidly.)
t
t
ON
ON
OFF
OFF
Slippage amount at clutch ON
Output speed
(Speed after clutch processing)
Clutch ON/OFF status
Clutch smoothing status
Input speed
(Speed before clutch
processing)
Slippage amount at clutch OFF
The speed changes depending on the input speed.