90
3 CAM FUNCTION
3.2 Create Cam Data
[Cd.611] Cam auto-generation data
Set the cam auto-generation data corresponding to "[Cd.610] Cam auto-generation type".
■Cam auto-generation parameter for rotary cutter
The cam data starting point for a rotary cutter is 0.
Buffer memory address Item Setting value Details
53204 Cam resolution 256/512/1024/2048/4096/8192/16384/32768 Set the cam resolution for generating the cam.
53206
53207
Sheet length 1 to 2147483647
[(Optional) Same unit (0.1mm, etc.)]
Set the sheet length.
Set this value in the cam axis length per cycle.
53208
53209
Sheet
synchronous
width
1 to 2147483647
[(Optional) Same unit (0.1mm, etc.)]
Set the sheet length of the synchronous section.
53210
53211
Synchronous
axis length
1 to 2147483647
[(Optional) Same unit (0.1mm, etc.)]
Set the cycle length of the rotary cutter shaft.
53212
53213
Synchronization
starting point
0 to 2147483647
[(Optional) Same unit (0.1mm, etc.)]
Set the length from the beginning of the sheet to the start
of the synchronous section.
53214 Synchronous
section
acceleration
ratio
-5000 to 5000[0.01%] Set when the synchronous speed in the synchronous
section needs to be adjusted.
The speed is "Synchronous speed (100% +
Acceleration ratio)" in the synchronous section.
Sheet length
Sheet synchronous width
Synchronization starting point
Cam axis position value per cycle
t
Sheet length
Sheet synchronous width
Synchronous
axis
(Cam axis)
Synchronization starting point
Synchronous axis length Synchronous axis cycle length
Feed sheet
t
Synchronous section acceleration ratio
When 0%, it is as fast
as synchronous speed.
Cam axis (Synchronous axis) speed
Synchronous speed
(Feed sheet speed)
t
100%
Cam stroke ratio
(Cam data by auto-generation)
To Next Page
Loading...
