6 USING THE PROGRAMMABLE CONTROLLER CPU MONITORING FUNCTION
6.2 Programmable Controller CPU Monitoring Function
129
6
■Transmission instruction of device information and programmable controller CPU status
information when transmitting the monitoring results
Use the following dedicated user frame numbers.
■Device information and programmable controller CPU status information
It is transmitted in the order of data shown below.
Page 130 Data arrangement of device information and programmable controller CPU status information
For ASCII-BIN conversion, set "ASCII-BIN conversion designation" to "ON".
When user frame is designated with the number, of which bit 14 for the numeric value indicating the user frame number is ON,
ASCII-BIN conversion of the corresponding send data is not performed. It will be transmitted as binary data. (Page 348
ASCII-BIN Conversion for Data Communicated with Nonprocedural Protocol)
Frame No. Information to be transmitted Valid function
Fixed cycle send Condition match send
B001H Device information for the block registered in
number n
Number 1
B002H Number 2
B003H Number 3
B004H Number 4
B005H Number 5
B006H Number 6
B007H Number 7
B008H Number 8
B009H Number 9
B00AH Number 10
B061H Programmable controller CPU status information (CPU error
monitoring data)
B080H Number of blocks to be sent
B081H Monitoring result information for all blocks
B082H Monitoring result information for blocks satisfying the conditions
To Next Page
Loading...
