26 PARAMETER SETTING
26.2 Module Parameters
435
26
Setting item
Item Description Reference
Transfer to intelligent function
module
Send data_send area A refresh setting for the send data storage area. Page 77 Transmitting
Data to Target Device
Page 96 Transmitting
Data to Target Device
Transfer to CPU LED lighting status,
communication error status
A refresh setting for confirmation of LED lighting status and
communication error status
Page 441 Checking error
status
Transmission control status A refresh setting for confirmation of transmission control
status
Page 447 Current
operation status reading
method
Control signal status A refresh setting for confirmation of control signal status Page 445 RS-232 control
signal status reading method
Communication result A refresh setting for confirmation of communication result Page 446 Data
communication status
(transmission sequence
status) reading method
Page 464 ERR LED
turns ON
Page 278 Data
Reception
For receive data A refresh setting for the receive data storage area Page 53 Receiving Data
from Target Device
Page 87 Receiving Data
from Target Device
Predefined protocol execution
status
A refresh setting for confirmation of predefined protocol
execution states
Page 113 Protocol
Execution Log Storage
Function (for Predefined
Protocol only)
Page 464 ERR LED
turns ON
Sending user frame A refresh setting for confirmation of user frame being
transmitted
Page 315 Settings of
send user frames
For user frame confirmation A refresh setting for confirmation of user frame
For modem function
confirmation
A refresh setting for confirmation of modem function Page 161 Details of the
buffer memory (for modern
function)
For remote password function A refresh setting for the remote password function Page 165 Details of
buffer memory (for the
remote password function)
Programmable controller CPU
monitoring function
A refresh setting for the programmable controller CPU
monitoring function
Page 119 USING THE
PROGRAMMABLE
CONTROLLER CPU
MONITORING FUNCTION
For flash ROM (user frame)
access
A refresh setting for the flash ROM (user frame) access
Transmission setting, for
mode switching confirmation
A refresh setting for confirmation of the transmission setting
and the mode switching
Page 377 SWITCHING
THE MODE AFTER
STARTING
Refresh group Refresh group A setting for the refresh group
• At the Execution Time of END Instruction
• At the Execution Time of Specified Program
Program group No. Designate the number which will be enabled when selecting
'At the Execution Time of Specified Program' for Refresh
group.
Refresh Timing (I/O) Refresh timing Sets the timing to transmit the I/O device data.
• It follows the refresh timing (buffer memory).
To Next Page
Loading...
