Mitsubishi Electric MELSEC iQ-RJ71C24-R2 - Page 81

3 DATA COMMUNICATION USING NONPROCEDURAL PROTOCOL
3.2 Transmitting Data to Target Device
79
3
Send data arrangement
The arrangement of data to be stored in the send area when transmitted to the target device is as shown in the example
below.
Ex.
When transmitting 'ABCDEFG123' (The send area is the default value.)
(B)
(2)
42 H
(1)
(C)(D)
44 H
(E)(F)
(G)(1)
(2)(3)
(A)
46 H
31 H
33 H 23 H
47 H
45 H
43 H
41 H
(4)(5)
35 H 34 H
CH1
address
Buffer memory
5 or 10
Transmission data count designation
In accordance with the word/byte units designation
Word units : 5
Bytes units : 10
Transmission data designation
Sequentially store the transmission data to low
address (L) → (H), next
address (L) → (H), in the order of transmission.
Un\G 1536
Un\G 1537
Un\G 1538
Un\G 1539
Un\G 1540
Un\G 1541
Un\G 1542