FUEL SYSTEM - INSTALLATION
3 - 29
2.1 Installing the governor weights
Install the governor weights onto the rear end of
the pump camshaft and tighten the sliding sleeve
shaft to the specified torque.
2.2 Installing the sliding sleeve
Install the sliding sleeve onto the sliding sleeve
shaft. Ensure that the sleeve slides smoothly.
2.3 Installing the governor assembly
(1) Install the governor assembly onto the pump
housing.
(2) Connect the tie-rod and the tie-rod spring to the
pumps.
(3) Install the tie-rod cover.
Installing the governor weights
Installing the sliding sleeve
Installing the governor assembly
Tightening torque:
29.4 to 41.2 N
m
(3.0 to 4.2 kgf
m)
[21.7 to 30.4 lbf
ft]
To Next Page
Loading...
