ELECTRICAL SYSTEM - DISASSEMBLY, INSPECTION AND REASSEMBLY
7 - 15
(6) Inspecting the overrunning clutch
(a) The shaft should rotate smoothly in one
direction, but should not rotate in the opposite
direction.
(b) Check the pinion for wear or damage. If faulty,
replace.
Do not wash the overrunning clutch in wash oil.
(7) Front bracket
The ball bearing should rotate smoothly without
abnormal noise. If faulty, replace the entire front
bracket.
(8) Internal gear, planetary gears, and armature shaft
gear
Replace if worn or damaged.
(9) Lever
As the lever’s friction surface with the
overrunning clutch wears, the pinion gap goes
out of the standard value. If so, adjust or replace
the lever.
(10) Magnet switch
Measure between M terminal and the body. If no
continuity is indicated, replace the magnet
switch.
Measure between B and M terminals. If
continuity is indicated, replace the magnet
switch.
Inspecting the overrunning clutch
Inspecting the magnet switch
B terminal
S terminal
M terminal
To Next Page
Loading...
