3. FEATURE menu
ITEM SETTING FUNCTION
ASPECT AUTO Select to change the aspect ratio automatically depending on the input signal.
4:3 Select to project images with an aspect ratio of 4:3.
16:9 Select to project images with an aspect ratio of 16:9. (Linearly stretched.)
ZOOM1 Select to enlarge and project images of CinemaScope size.
ZOOM2
Select to enlarge and project images of Vista size.
STRETCH Select to enlarge to 16:9 and project of the images with an aspect ratio of 4:3. (Non-
linearly stretched.)
ANAMORPHIC1 This mode is suitable for viewing 2.35:1-size images using the anamorphic lens.
Use the p or q key to adjust the vertical display position.
This mode doesn’t support input signals from personal computers.
ANAMORPHIC2 This mode is suitable for viewing 16:9- or 4:3-size images or images input from personal
computers using the anamorphic lens.
PASSWORD FUNCTION
Use to enable or cancel the password lock. See page 35 for details.
MENU POSITION 2 options Use to change the position of the menu.
MENU DIMMER ON / OFF Use to reduce the brightness of the menu.
CINEMA MODE AUTO The film mode will be automatically activated when a film source signal is input.
Select AUTO for normal use.
When flicker occurs on the screen or jaggies on slanting lines are remarkable, select
FILM when a film source signal is input or select VIDEO for other signals.
VIDEO The film mode will not be activated.
FILM Fixed to the film mode.
VIDEO SIGNAL 8 options When AUTO is selected, the appropriate video format is automatically selected
depending on the input signal. If the image isn’t displayed correctly, select the desired
video format manually.
SETUP AUTO
Select AUTO for normal use. When LANGUAGE is not set to and 480i, 480p or
TV60 signal is input, the SETUP changes to 7.5% automatically.
OFF Select to make black lighter.
3.75% / 7.5%
Select to make black intense.
When 7.5% is chosen, the brightness is decreased by the set-up cancel function for
the U.S. Choose OFF when the image is dark.
•
SCART INPUT ON / OFF Choose ON when connecting the projector with a device equipped with the SCART
terminal that can output RGB signal. SCART terminal is used mainly in Europe.
Choose OFF normally. (Available only for the input signal from the COMPUTER IN/
COMPONENT VIDEO IN terminal.)
LANGUAGE 10 languages Use to select the language used in the menus.
RESET ALL
OK
Use to reset the settings of the menu (excluding PASSWORD FUNCTION and
LANGUAGE) to the factory setting values.
When SCREEN SIZE of ADVANCED MENU is set to CINEMA SCOPE(2.35:1) in the IMAGE menu, STRETCH,
ANAMORPHIC1 and ANAMORPHIC2 cannot be selected for ASPECT.
When SCART INPUT is set to ON, normal computer signals aren’t projected.
Use a SCART-BNC (or SCART-Mini D-SUB 15-pin) cable (option) when connecting this projector with an AV device
equipped with the SCART terminal.
Some AV devices equipped with the SCART terminal aren’t compatible with this projector.
It may take a little while to carry out RESET ALL in the FEATURE menu.
•
•
•
•
•
To Next Page
Loading...
Need help?
General
Weight and Dimensions
