Mitsubishi HC4000 User Manual

EN-44
This projector has two indicators, each of which shows the operation condition of the projector.
The following offer solutions to possible problems. If these problem persist, turn the projector off and consult your
dealer.
POWER indicatorSTATUS indicator
Normal condition
POWER STATUS CONDITION NOTE
Steady red
Off
Stand-by
Steady green Blinking green
Lamp stand-by (about 1 minute) The power cannot be turned off by
pressing the POWER button.
Steady green Steady green
The power is on. (Normal condition)
Abnormal condition
POWER STATUS CONDITION POSSIBLE SOLUTION
Steady green
or
Steady red
Blinking orange
Abnormal temperature
The ventilation grilles are clogged with dust or
dirt.
The room temperature is high.
•
•
Clean the ventilation grilles.
Relocate the projector to a cooler
place.
•
•
Steady red Blinking green
The protection circuit is working or the lamp is in an
abnormal condition.
Wait until the STATUS indicator goes
out, then press the POWER button.
If the above solution is not effective,
replace the lamp.
•
•
Steady green
Blinking green/red
The lamp operation time exceeds the time elapsed
until the shut-off time notice while the power is on.
(See page 36.)
Replace the lamp.
Change with a new lamp if this problem
recurs.
Steady red Blinking red
The lamp operation time exceeds the time elapsed
until the shut-off time notice while the power is off.
(See page 36.)
Steady red Steady red
The lamp operation time exceeds the time elapsed
until the shut-off time. (See page 36.)
Blinking green/red
Off
The lamp cover isn’t closed. Close the cover correctly.
Blinking green/red
Steady or
Blinking
Abnormal. Contact your dealer.
Indicators

Mitsubishi HC4000 Specifications

General

Matrix size	0.65 \
Native aspect ratio	-
Projection distance	- m
Vertical scan range	50 - 85 Hz
Horizontal scan range	15 - 80 kHz
Projection technology	DLP
Supported aspect ratios	4:3, 16:9
Contrast ratio (typical)	4000:1
Screen size compatibility	50 - 300 \
Projector native resolution	1080p (1920x1080)
Focus	Manual
Focal length range	- mm
Lamp power	230 W
Light source type	Lamp
Lamp power (economic mode)	190 W
Service life of light source	3000 h
Service life of light source (economic mode)	5000 h
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Ethernet LAN	No
Full HD	Yes
Supported video modes	1080i, 1080p, 480i, 480p, 576i, 576p, 720i, 720p
Analog signal format system	NTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Placement	Desktop
Product type	Standard throw projector
Product color	Black
Power source	AC
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	- W
Power consumption (typical)	340 W
Noise level	31 dB
Noise level (economic mode)	25 dB
Dot clock scanning frequency	170 MHz

Weight and Dimensions

Weight	3600 g