EasyManua.ls Logo

Mitsubishi LE-30CTN - Page 22

Mitsubishi LE-30CTN
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
3.2 Method of change screen
3. Screen system and method of change screen
20
2) To switch the screen by selecting an item number
Set an item number using the value dial(16).
If the selected item has only one screen, pressing the T or S keys will return the system to the adjustment/
setting item selection screen.
If the selected item has two or more screens, use the T and S keys to switch the screen. If the uppermost
screen is displayed, pressing the S keys will return the system to the adjustment/setting item selection
screen. If the lowermost screen is displayed, pressing the T key will return the system to the adjustment/
setting item selection screen.
If a screen has two or more items, pressing the T or S key will move the under-cursor to the next or
previous item. However, if the cursor is at the uppermost item, pressing the S key will return the system to
the adjustment/setting item selection screen. If the cursor is at the lowermost item, pressing the T key will
return the system to the adjustment/setting item selection screen.
20: Full-scale tension
value, decimal
point setting
21: Tension indication
filter time constant
setting
30: Tension output
filter time constant
setting
31: Low excitation
setting
10: Stop gain,
stop timer setting
22: Manual zero point
adjusting
23: Manual span
adjusting
40:
Proportional gain,
integral time
setting
41: Additional gain,
addition dead
zone setting
50:
Contact input
setting for MI1,
MI2, MI3
51:
Analog input
setting for AI1, AI2
52:
Extension screen
setting
Adjustment/setting
item selection screen
Power-on
54: Pass word
setting
Password
input screen
2:Manual Setting
1:Tension setting
3:Taper rate setting
11: Gain 1,
gain 2 setting
26: Zero tension
detection
When a password setting value is zero (default), the
password input screen is not displayed, and the
adjustment/setting item selection screen is displayed
wen the power is turned ON.
Select an item number using the setting dial(16), and
then press the T key (screen selection key) to move
to the screen of the selected item.

Table of Contents

Related product manuals