Mitsubishi LE-30CTN - 8 Other Functions; Menu Function; Switching Menu Number; Data Storage

39
8.1 Menu function
8. Other Functions
8. Other Functions
8.1 Menu function
• 8 types of operation data can be stored or read, and also the data can be copied between different menu
numbers by using the menu function.
• This menu function is useful to process materials having different operation conditions.
8.1.1 Switching menu number
• Press the X key of the menu selection key(17) and the menu number will be incremented by one, and
press the W key and the menu number will be decremented by one. The operation data corresponding to
the menu number will be valid.
When the menu number is "8", pressing the X key will go to menu 1. When the menu number is "1",
pressing the W key will go to menu 8.
• The menu number will appear at the upper right section of the liquid
crystal display. (The menu number will be displayed only when the
screen data can be stored in the menu function.)
8.1.2 Data storage
• In the list of setting items, the items marked with A in the "Menu" can be stored. - - - - - -Refer to Sec. 12.3.
• The data displayed on the screen can be stored by assigned the displayed menu number.
• Initial setting value is preliminarily stored for each menu number.
8.1.3 Data copy between menus
[1] Turn OFF DIP switch 8, and then turn ON the power to enter the
adjustment mode.
[2] Press the [F4] function key to move to the menu copy screen.
[3] Set the original menu number by the X or W key of the menu selection
key(17).
[4] Set the copy destination menu number by the setting dial(16).
[5] Press the [GO] key.
Menu numbe
r
F4
F4
Menu copy screen
F1 F2 F3 F4
Adjustment/setting item
selection screen