23
4.3 Adjustment of tension detector
4. Adjustment and Initial Setting
4.3.2 Adjustment of zero point and span for tension detector
- - - - - - - - - - - - Turn OFF DIP switch 8, and then turn ON the power to enter the adjustment mode.
1) Zero point adjustment for tension detector
• Correct the zero point of the tension detector (tare weights of the detector roller, bearing, etc.). For
this correction, be sure to install the detector roller, and do not thread the material into the machine.
[1] Press the [F2] function key to move to the auto zero tuning screen.
[2] Do not thread the material into the machine, but apply the tare
weights of the detector roller, bearing, etc., and then press the [GO]
key.
[3] The message "NOW EXECUTING" will be displayed for
approximately 2 seconds.
[4] The message "FINISH" or an error message will appear. If an error
message appears, check the problem while referring to pages 46,
48.
F1 F4
Auto zero tuning
screen
F1 F2 F3 F4
Adjustment/setting
item selection screen
To Next Page
Loading...
