Mitsubishi MELSEC-F FX-1GM - Page 72

L
(3) Coding
The following instructions form the program for this fixed size cutting example.
Note: Since the FX- 1 GM employs a sequential instruction-by-instruction operation, the ON/OFF
condition will not be read unless the instruction concerned is being executed.
In this regard, the
FX- 1 GM uses such a cycle method to wait for the input.
Momentary operations such as pushbuttons, etc. will not be accepted if the pulse is less than
10 msec (except for INT and VCH instructions).
-70-