2-40
Seat and seat belts
2
Seat belt pre-tensioner system and force
limiter system
E00405700166
The driver’s seat and front passenger’s seat each have a seat
belt equipped with a pre-tensioner system.
Pre-tensioner system
E00405800662
The pre-tensioner system will retract their respective seat belts
instantaneously, thus maximizing the seat belt’s effectiveness,
if there is a frontal impact severe enough to injure the driver
and/or front passenger and the ignition switch is in the “ON” or
“START” position.
OTE
● The pre-tensioner seat belts will be activated if the vehicle
suffers a severe frontal impact, even if the seat belts are
not worn.
● The pre-tensioner seat belts are designed to work only
once. After the pre-tensioner seat belts have been acti-
vated, we recommed you have it replaced by a MITSUBI-
SHI MOTORS Authorised Service Point.
WARNING
!
● To obtain the best results from your pre-tensioner
seat belt, make sure you have adjusted your seat
correctly and wear your seat belt properly.
CAUTION
!
● Any installation of audio equipment or repairs in the
vicinity of the pre-tensioner seat belts or floor con-
sole must be performed in line with MITSUBISHI
MOTORS guidelines. It is important to do so
because the work could affect the pre-tensioner sys-
tems.
● If you need to scrap the vehicle, please consult a
MITSUBISHI MOTORS Authorised Service Point.
It is important to do so because unexpected activa-
tion of the pre-tensioner seat belts could cause inju-
ries.
To Next Page
Loading...
Need help?
General
