1-4
Locking and unlocking
1
● The engine is designed so that it will not start if the
IDcode registered in the immobiliser computer and the
key’s ID code do not match. Refer to the section entitled
“Electronic immobiliser” for details and key usage.
Keys should never be placed in areas which contain mag-
netic or metal objects as this may interfere with the trans-
ponder.
● The key is a precision electronic part with a built-in signal
transmitter. Please observe the following in order to pre-
vent a malfunction.
• Do not leave anywhere that is exposed to direct sunlight,
for example on the dashboard.
• Do not disassemble or modify.
• Do not excessively bend the key or subject it to a strong
impact.
• Do not expose to water.
• Keep away from magnetic key holders.
• Keep away from audio systems, personal computers,
TVs, and any other equipment that generates a magnetic
field.
• Do not wash with ultrasonic cleaners or similar equip-
ment.
• Do not leave the key where it may be exposed to high
temperature or high humidity.
Electronic immobiliser
(Anti-theft starting system)
E00300200703
[For vehicles equipped with the keyless operation system].
For information on operations for vehicles equipped with the
keyless operation system, refer to “keyless operation system :
Electronic immobiliser (Anti-theft starting system)” on page
1-16.
[Except for vehicles equipped with the keyless operation
system].
The electronic immobiliser is designed to reduce significantly
the possibility of vehicle theft. The purpose of the system is to
immobiliser the vehicle if an invalid start is attempted. A valid
start attempt can only be achieved by using a key “registered”
to the immobiliser system.
To Next Page
Loading...
Need help?
General
