8-40
Maintenance
8
Position lamps
E01003700338
1. When replacing the bulb on the right side of the vehicle,
remove the bolt (A) fastening the washer fluid reservoir
spout and move the spout in the rear direction.
CAUTION
!
● Handle halogen lamp bulb with care. The gas inside
halogen lamp bulb is highly pressurized, so drop-
ping, knocking, or scratching a halogen lamp bulb
can cause it to shatter.
● Never hold the halogen lamp bulb with a bare hand,
dirty glove, etc.
The oil from your hand could cause the bulb to
break the next time the headlamps are operated.
If the glass surface is dirty, it must be cleaned with
alcohol, paint thinner, etc., and refit it after drying
thoroughly.
To Next Page
Loading...
Need help?
General
