For pleasant driving
5-77
5
Manual mode
The manual mode is also available in case the “Automatic
mode” shows the incorrect time when the adjacent local RDS
stations are located in a different time zone. Refer to “Radio
data system (RDS)” on page 5-23, 5-46.
Set the time by pressing the various buttons as described
below.
1. Keep the CLOCK button pressed until the time display
flashes.
2. Press the appropriate buttons to adjust the time.
3. Once the time is set, press the “DISP” button, and the time
display will stop flashing.
When a time adjustment has been made, the flashing stops
automatically.
OTE
● If the battery cables are disconnected during repairs or for
any other reason, reset the clock to the correct time after
they are reconnected.
● The digital clock does not have a second display. When
the “minute” display is adjusted and reset to zero, the
clock begins at zero seconds for the selected minute.
“H” button - To adjust the hour
“M” button - To adjust the minutes
“:00” button - To reset the minutes to zero
10:01 - 10:29...... Changes to 10:00
10:30 - 10:59...... Changes to 11:00
CLOCK DISP H M
:00
To Next Page
Loading...
Need help?
General
