For emergencies
6-23
6
Wheel covers*
E00801300315
To remove
Wrap the tip of the jack bar with a cloth, insert it deeply into
the notch provided in the wheel cover, and pry the cover away
from the wheel. Using the same procedure at the other wheel
cover notches, work the wheel cover away from the wheel to
remove it completely.
OTE
● The wheel cover is made of plastic. Pry it loose carefully.
To instal l
1. Make sure the tabs (A) of the back of the wheel cover are
not broken and correctly fitted on the rings (B). If in
doubt, do not install the wheel cover and consult your
MITSUBISHI MOTORS Authorised Servise Point.
CAUTION
!
● Removing the cover with your hands may cause
injury to the fingers.
To Next Page
Loading...
