3-50
Instruments and controls
3
Indicator lamps
E00501600100
Turn-signal indicator lamps/Hazard
warning indicator lamps
E00501700172
These indicator lamps blink on and off when a
turn-signal lamp is operating.
NOTE
● If the blinking is too fast, the cause may be
a blown lamp bulb or a faulty turn-signal
connection.
When the hazard warning lamp switch is
pressed, all turn-signal lamps will flash on and
off continuously.
High-beam indicator lamp
E00501800173
This indicator lamp illuminates when the high
beam is used.
Front fog lamp indicator lamp *
E00501900350
This lamp illuminates while the front fog lamps
are on.
Rear fog lamp indicator lamp
E00502000127
This lamp illuminates while the rear fog lamps
are on.
Position lamp indicator lamp
E00502300074
This lamp illuminates with the lamp switch at
“ ” or “ ” position.
Diesel preheat indicator lamp
This indicator lamp illuminates when the igni-
tion switch is placed in the “ON” position. As
the glow plug becomes hot, the lamp goes out
and the engine can be started.
NOTE
● If the engine is cold, the diesel preheat indi-
cator lamp is on for a longer time.
● When the engine has not been started within
about 5 seconds after the diesel preheat
indicator lamp went out, return the ignition
switch to the “LOCK” position. Then, turn
the switch to the “ON” position to preheat
the engine again.
● When the engine is warm, the diesel preheat
indicator lamp does not come on even if the
ignition switch is placed in the “ON” posi-
tion.
To Next Page
Loading...
Need help?
General
