Instruments and controls
3-41
3
Information screen display list
E00523900015
When there is information to be announced, such as lamp reminders, a sound is emitted and the screen switches to the displays
shown below. Refer to the appropriate page and take the necessary measures.
When the cause of the warning display is eliminated, the warning display goes out automatically.
Refer to “Warning display list (when the ignition switch is “OFF”)” on page 3-42.
Refer to “Warning display list (when the ignition switch is “ON”)” on page 3-44.
Refer to “Other interrupt displays (when the ignition switch is “ON”)” on page 3-48.
OTE
● A warning may be displayed on the information screen and the buzzer may sound in the following rare cases.
This is caused by the system picking up interference such as noise or strong electromagnetic waves, and is not a functional
problem.
• An extremely strong electromagnetic wave is received from a source such as an illegal radio set, a spark from a wire, or a
radar station.
• Abnormal voltage or a static electricity discharge is generated by the operation of installed electrical equipment (including
after-market parts).
If the warning display appears many times, we recommend you to consult a MITSUBISHI MOTORS Authorised Service
Point.
To Next Page
Loading...
Need help?
General
