4-18
Starting and driving
4
5. Turn the ignition key to the “ON” position.
The diesel preheat indicator lamp will first illuminate, and
then after a short time go out, indicating that preheating is
completed.
OTE
● If the engine is cold, the diesel preheat indicator lamp is
on for a longer time.
● When the engine has not been started within about 5 sec-
onds after the diesel preheat indicator lamp went out,
return the ignition key to the “LOCK” position. Then, turn
the key to the “ON” position to preheat the engine again.
● When the engine is warm, the diesel preheat indicator
lamp does not come on even if the ignition key is placed
in the “ON” position.
Start the engine by turning the ignition key right to the
“START” position.
6. Turn the ignition key to the “START” position without
depressing the accelerator pedal, and release it when the
engine starts.
OTE
● A ticking noise may be heard after starting the engine.
This is not an abnormal condition. The noise will disap-
pear after a short time of engine running.
If the ticking noise continues after the engine is warmed
up, we recommend you to have your vehicle checked.
Fuel injection amount learning process
E00616000057
To keep exhaust emissions and engine noise low, the engine
very occasionally performs a learning process for the fuel
injection amount.
The engine sounds slightly different from usual while the
learning process is taking place. The change in the engine
sound does not indicate a fault.
To Next Page
Loading...
Need help?
General
