Starting and driving
4-33
4
ABS waning lamp / display
E00607200503
If there is a malfunction in the system, the ABS warning lamp
will come on and “SERVICE REQUIRED” will appear on the
information screen in the multi-information display.
Under normal conditions, the ABS warning lamp only comes
on when the ignition switch is turned to the “ON” position and
goes off a few seconds later.
CAUTION
!
● Even the ABS cannot prevent the natural laws of
physics from acting on the vehicle. It cannot for
instance avoid accidents that may result from exces-
sive speed on bends or following another vehicle too
closely or aquaplaning. It should remain the driver’s
task to observe safety precautions to judge speeds
and brake applications correctly in such conditions.
● Be sure to use tyres of the same type and size on 4
wheels.
If tyre types or sizes are mixed, ABS may not func-
tion normally.
● Never install a limited slip differential, which is not
MITSUBISHI Genuine parts, as the ABS may not
function normally.
We recommend you to consult a MITSUBISHI
MOTORS Authorised Service Point.
CAUTION
!
● Any of the following warning lamp/display behavior
indicates that the ABS is not functioning and only
the standard brake system is working (the standard
brake system is functioning normally). If this hap-
pens, take your vehicle to a MITSUBISHI
MOTORS Authorised Service Point.
• When the ignition switch is in the “ON” position,
the warning lamp does not come on or it remains
on and does not go off
• The warning lamp comes on while driving
• The warning display appears while driving
To Next Page
Loading...
Need help?
General
