4-48
Starting and driving
4
Obstacle detection areas
E00615600102
The detection areas of the corner and back sensors are limited
to those shown in the illustration. Moreover, the sensors are
unable to detect low or thin objects or objects near the rear
bumper. Thus, make sure to check the surroundings as you
operate the vehicle in a safe manner.
Corner and back sensor locations
There are two corner sensors (A) at the corners of the rear
bumper, and two back sensors (B) in the centre of the rear
bumper.
Reversing sensor system detection areas
Depending on whether the vehicle is equipped with a towbar,
you can change the reversing sensor system between the stand-
ard mode and the towbar mode. The towbar mode changes the
system to exclude the area in which the towbar is mounted
from the detection areas.
Vehicles without a towbar
The detection areas are within approximately 60 cm (A) from
the corner sensors, 150 cm (B) from the back sensors, and 60
cm (C) or less from the ground surface, excluding the area
approximately 10 cm (D) from the ground surface.
To Next Page
Loading...
Need help?
General
