OTE
● If you pull on the door handle too quickly, it may not
unlock. If this happens, grip the handle again, check that
the doors and tailgate have been unlocked, and then pull
on the handle.
● If the keyless operation key is within the operating range
of the exterior transmitter and a carwash or strong rain
gets a large amount of water on the door handle, the key-
less operation system may be triggered and the vehicle
unlocked. If this happens, the vehicle is automatically
locked again after about 30 seconds.
Operation confirmation when locking and unlocking
Operation can be confirmed as shown below. However, the
room lamp will only illuminate if the room lamp switch is in
the “DOOR” position.
OTE
● Functions can be modified as stated below. For further
information, please contact your authorised MITSUBISHI
MOTORS dealer.
• Set the confirmation function (flashing of the turn-signal
lamps) to operate only when the vehicle is locked or
only when the vehicle is unlocked.
• Disable the operation confirmation function (flashing of
the turn-signal lamps) and buzzer.
• Change the number of blinks for the operation confirma-
tion function (blinks of the turn-signal lamps).
• Make the buzzer sound if the keyless operation key is
taken out of the vehicle with all the doors and the tail-
gate closed.
When locking: The turn-signal lamps blink once and the
buzzer sounds once.
When unlocking: The room lamp illuminates for about 15 sec-
onds, the turn-signal lamps blink twice, and the
buzzer sounds twice.
To Next Page
Loading...
Need help?
General
