6-16
For emergencies
6
2. Loosen the tyre hanger installation bolt by turning it anti-
clockwise with the wheel nut wrench.
3. Raise the lower gate until it locks properly in position
with a click.
Refer to “Tailgate: To open” on page 1-43.
4. Lift up the tyre hanger (B) at the section indicated by the
arrow in the diagram, remove it from the hook (C), lower
it, and then take the tyre off the tyre hanger.
CAUTION
!
● Be careful as you loosen the tyre hanger installation
bolt. If you loosen it too far, the hook may come out
and let the compact spare wheel fall.
CAUTION
!
● When removing the tyre hanger from the hook or
hanging it back on the hook, hold the tyre hanger
carefully so that it does not drop on your feet.
To Next Page
Loading...
Need help?
General
