OTE
● If the engine is cold, the diesel preheat indicator lamp is
on for a longer time.
● When the engine has not been started within about 5 sec-
onds after the diesel preheat indicator lamp went out,
return the ignition key to the “LOCK” position. Then, turn
the key to the “ON” position to preheat the engine again.
● When the engine is warm, the diesel preheat indicator
lamp does not come on even if the ignition key is placed
in the “ON” position.
Start the engine by turning the ignition key right to the
“START” position.
6. Turn the ignition switch to the “START” position without
depressing the accelerator pedal, and release it when the
engine starts.
OTE
● A ticking noise may be heard after starting the engine.
This is not an abnormal condition. The noise will disap-
pear after a short time of engine running.
If the ticking noise continues after the engine is warmed
up, please contact your authorized MITSUBISHI
MOTORS dealer.
To operate without using the keyless operation
function
E00306000019
Emergency key
E00307200018
The emergency key is built into the keyless operation key. If
the keyless operation function cannot be used, for example
because the keyless operation key battery has worn out or the
vehicle battery is flat, you can lock and unlock the doors and
start the engine with the emergency key. Take the emergency
key out of the keyless operation key and use it.
To Next Page
Loading...
