Outside rearview mirrors
5-60 Features and controls
When the headlights of the vehicles behind
you are very bright, the reflection factor of
the rearview mirror is automatically changed
to reduce the glare.
Normally, use the automatic mode. When the
ignition switch is turned to the “ON” position
or the operation mode is put in ON, the green
indicator (1) illuminates and the reflection
factor of the mirror is automatically changed.
N00512201232
Adjust the outside rearview mirrors only after
making any seat adjustments so as to have a
clear view to the rear of the vehicle.
If you want to stop automatic mode, press
the switch (3) for approximately 2 seconds
and the indicator (1) will go off.
To return to automatic mode, press the
switch again or perform the following opera-
tion.
[Except for vehicles equipped with the Free-
hand Advanced Security Transmitter
(F.A.S.T.-key)]
Turn the ignition switch to the “ON” position
after turning to “OFF” or “ACC” position.
[For vehicles equipped with the Free-hand
Advanced Security Transmitter (F.A.S.T.-
key)]
Put the operation mode in ON after putting
the operation mode in OFF.
Type 4
Do not hang items on, or spray glass cleaner
on the sensors (2), as reduced sensitivity
could result.
If you want to stop automatic mode, press
the switch (3) and the indicator will go off.
To return to automatic mode, press the
switch again or perform the following opera-
tion.
[Except for vehicles equipped with the Free-
hand Advanced Security Transmitter
(F.A.S.T.-key)]
Turn the ignition switch to the “ON” position
after turning to “OFF” or “ACC” position.
[For vehicles equipped with the Free-hand
Advanced Security Transmitter (F.A.S.T.-
key)]
Put the operation mode in ON after putting
the operation mode in OFF.
Outside rearview mirrors
Do not attempt to adjust the outside rear-
view mirrors while driving. This can be
dangerous.
Be sure to adjust the mirrors before driv-
ing.
BK0239700US.book 60 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
