EasyManuals Logo

Mitsubishi Outlander 2017 User Manual

Mitsubishi Outlander 2017
521 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #174 background imageLoading...
Page #174 background image
Brake auto hold (if so equipped)
Features and controls 5-93
5
N00550700124
The disc brakes have an alarm that makes a
metallic squeal when the brake pads have
worn down enough to need service.
If you hear this sound, have the brake pads
replaced at an authorized Mitsubishi Motors
dealer or a repair facility of your choice.
N00592000035
When the vehicle is stopped at traffic lights
etc., the vehicle can be held stationary with
the brake auto hold system even if you
release your foot from the brake pedal.
When the accelerator pedal is depressed, the
brakes are released.
If the brake auto hold switch is pressed while
all of the following conditions are met, the
system will change to the standby state and
the indicator light (A) on the switch comes
on.
The operation mode in ON.
The driver’s seat belt is fastened.
The driver’s door is closed.
WARNING
Never coast downhill with the engine OFF.
Keep the engine running whenever your
vehicle is in motion. If you turn off the
engine while driving, the power brake
booster will stop working and your brakes
will not work as well.
If the power assist is lost or if either brake
hydraulic system stops working properly,
take your vehicle to an authorized Mit-
subishi Motors dealer or a repair facility
of your choice immediately.
Brake pad wear alarm
WARNING
Driving with worn brake pads will make it
harder to stop, and can cause an accident.
Brake auto hold (if so equipped)
WARNING
Do not overly rely on the brake auto hold
system. On steep slope, depress the brake
pedal firmly because the system may not
hold the vehicle stationary.
Never leave the vehicle while it is being
stopped by the brake auto hold system.
When leaving the vehicle, apply the park-
ing brake and move the selector lever to
the “P” (PARK) position.
Do not use brake auto hold system when
driving on slippery roads. The system may
not hold the vehicle stationary and could
result in an accident.
NOTE
While operating the brake auto hold system,
you may hear an operation noise to increase
braking force when the system detected the
movement of the vehicle. This does not indi-
cate a malfunction.
How to use brake auto hold
To turn on brake auto hold
BK0239700US.book 93 ペー 2016年6月16日 木曜日 午前10時58分

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mitsubishi Outlander 2017 and is the answer not in the manual?

Mitsubishi Outlander 2017 Specifications

General IconGeneral
BrandMitsubishi
ModelOutlander 2017
CategoryAutomobile
LanguageEnglish

Related product manuals