Blind Spot Warning (BSW) (with Lane Change Assist) (if so equipped)
Features and controls 5-131
N00586800038
Every time the operation mode is turned to
“ON”, the Ultrasonic misacceleration Mitiga-
tion System will automatically be turned on.
In addition, on vehicles equipped with the
Forward Collision Mitigation System (FCM),
the Ultrasonic misacceleration Mitigation
System and the FCM are simultaneously
turned off and on by operating the FCM and
Ultrasonic misacceleration Mitigation System
ON/OFF switch.
Refer to “FCM and Ultrasonic misaccelera-
tion Mitigation System ON/OFF switch” on
page 5-122.
N00586900026
N00587000037
Example: When the front and/or rear sensors
are temporarily not available
This display will appear if more than one sen-
sor is temporarily not available for some rea-
son such as an environmental condition. This
can typically occur when the sensor is heated.
When the radar sensor performance returns,
the message will disappear and the system
will resume operation.
If the message is continuously displayed,
contact an authorized Mitsubishi Motors
dealer or a repair facility of your choice.
N00587100038
Example: When there is a malfunction in
both sensors
If the Ultrasonic misacceleration Mitigation
System detects a malfunction in the system,
the Ultrasonic misacceleration Mitigation
System will not operate normally and this
massage is displayed.
Have the vehicle inspected at an authorized
Mitsubishi Motors dealer or a repair facility
of your choice.
N00592200024
The Blind Spot Warning (BSW) is a driving
aid system that alerts the driver when another
vehicle which may not be visible through the
outside rearview mirror is traveling in the
next lane behind your vehicle.
The ultrasonic sensors do not detect objects
in areas directly below or very close to the
bumpers. If the height of an object is lower
than the sensors, the sensors may not con-
tinue detecting it while the vehicle is
approaching the object, even if the sensors
can initially detect it.
To turn on/off the Ultrasonic
misacceleration Mitigation Sys-
tem
Warning display
When the sensor is temporarily
not available
When there is a malfunction in the
sensor or the system
Blind Spot Warning (BSW)
(with Lane Change Assist) (if
so equipped)
BK0239700US.book 131 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
