Replacement of light bulbs
Vehicle care and maintenance 9-31
4. Use the fuse location diagrams and the
matching tables, to check the fuse that is
related to the problem. If the fuse is not
blown, something else must be causing
the problem. Have the system inspected
by your authorized Mitsubishi Motors
dealer or a repair facility of your choice.
5. Insert a new fuse of the same capacity
securely into the appropriate slot.
N00942901391
Before replacing the bulb, be sure the light is
off. Do not touch the glass part of the new
bulb with your bare fingers; the oil from your
skin will stay on the glass and dim or destroy
the bulb when it gets hot.
B- Fuse is OK
C- Blown fuse
Never use a fuse with a capacity greater than
the one listed or any substitute, such as wire,
foil etc. This would cause the circuit wiring
to heat up and could cause a fire.
If the replacement fuse blows again after a
short time, have the electrical system
checked by an authorized Mitsubishi Motors
dealer or a repair facility of your choice to
find and correct the cause.
Replacement of light bulbs
Bulbs are extremely hot immediately after
being turned off.
When replacing the bulb, wait for it to cool
sufficiently before touching it. You could
otherwise be burned.
Handle halogen light bulb with care. The gas
inside a halogen light bulb is highly pressur-
ized, so dropping, knocking, or scratching a
halogen light bulb can cause it to shatter.
Never hold the halogen light bulb with a bare
hand, dirty glove, etc.
The oil from your hand could cause the bulb
to break the next time the headlights are
used.
If the glass surface is dirty, clean it with
alcohol and let it dry completely before
installing the bulb.
Do not install commercially available LED-
type bulbs. Commercially available LED-
type bulbs could adversely affect the opera-
tion of the vehicle, such as by preventing the
lights and other vehicle equipment from
operating properly.
BK0239700US.book 31 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
