Tire pressure monitoring system
5-142 Features and controls
If the LDW is deactivated due to a malfunc-
tion in the system, the either alarm shown
below is displayed. Contact your authorized
Mitsubishi Motors dealer for inspection of the
system.
N00530201638
The tire pressure monitoring system uses tire
inflation pressure sensors (A) on the wheels
to monitor the tire inflation pressures. The
system only indicates when a tire is signifi-
cantly under-inflated.
LDW deactivation due to fault
If the sensor or its surrounding area becomes
extremely high temperature when parking
the vehicle under a blazing sun, the “LDW
SERVICE REQUIRED” message may
appear.
If the message remains even after the tem-
perature of the sensor or its surrounding area
has been in range, please contact an autho-
rized Mitsubishi Motors dealer.
Tire pressure monitoring
system
The compact spare wheel does not have a
tire inflation pressure sensor.
When the spare tire is used, the tire pres-
sure monitoring system will not work
properly.
See an authorized Mitsubishi Motors
dealer as soon as possible to replace or
repair the original tire.
The tire pressure monitoring system is not a
substitute for regularly checking tire infla-
tion pressures.
Be sure to check the tire inflation pressures
as described in “Tires” on page 9-15.
The tire inflation pressure sensor (B) is
installed in the illustrated location.
• On vehicles with Type 1 sensor which has
the metallic air valve (C), replace grommet
and washer (D) with the new ones when the
tire is replaced.
• On vehicles with Type 2 sensor which has
the rubber air valve (E), replace rubber air
valve (E) with new one when the tire is
replaced.
BK0239700US.book 142 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
Need help?
General
