Blind Spot Warning (BSW) (with Lane Change Assist) (if so equipped)
5-132 Features and controls
When a vehicle in the next lane is traveling at
same speed or faster in the detection areas,
the Blind Spot Warning light in the corre-
sponding outside rearview mirror will illumi-
nate. If the turn signal lever is operated to the
side where the Blind Spot Warning light is
illuminated, the Blind Spot Warning light will
blink and the system will beep three times to
alert the driver.
Depending on the speed of your vehicle, the
Blind Spot Warning system will detect up to
approximately 230 feet (70 m) from your
vehicle.
N00592300038
The BSW uses 2 sensors (A) located inside
the rear bumper.
The detection areas are shown as illustrated.
Before using the BSW, read this entire sec-
tion to fully understand the limitations of
this system. Failure to follow instructions
could result in an accident.
Never rely solely on the BSW system when
changing lanes. BSW is an aid only. It is
not a substitute for your safe and careful
driving. Always check visually behind and
all around your vehicle for other vehicles.
The performance of the BSW may vary
depending on driving, traffic and/or road
conditions.
Detection areas
In certain situations, the BSW may not
detect a vehicle in the detection areas or
the detection may be delayed. Some of
these include;
• When a small motorcycle or a bicycle is
behind your vehicle.
• When a vehicle is traveling alongside of
your vehicle at nearly the same speed for
prolonged periods of time.
BK0239700US.book 132 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
