Automatic transaxle (if so equipped)
Features and controls 5-69
N00563101086
When the selector lever cannot be shifted
from the “P” (PARK) position to another
position while the brake pedal is pressed and
held down with the operation mode in ON,
the battery may be flat or the shift-lock mech-
anism may be malfunctioning.
Immediately have your vehicle checked by an
authorized Mitsubishi Motors dealer or a
repair facility of your choice.
If you need to move the vehicle, shift the
selector lever as follows.
1. Make sure the parking brake is firmly
applied.
2. Stop the engine if it is running.
3. Insert a screwdriver with a cloth over its
tip into the notch (A) of the cover. Pry
gently as shown to remove the cover.
4. Depress the brake pedal with the right
foot.
5. Insert a screwdriver in the shift-lock
release hole (B). Shift the selector lever to
the “N” (NEUTRAL) position while
pressing the screwdriver down.
Always press the brake pedal when shift-
ing the selector lever into a gear from the
“N” (NEUTRAL) position.
When beginning to drive, do not shift the
selector lever from the “N” (NEUTRAL)
position while pressing the accelerator
pedal. This will cause the vehicle to
“jump” forward or backward.
To prevent mistakes in operating the lever,
make sure you stop briefly at each position.
After operating, check the position in the
multi-information display.
If the brake pedal is not depressed and held,
the shift-lock device activates to prevent the
selector lever from being moved from the
“P” (PARK) position.
For a shift indicated by in the illustra-
tion, depress the brake pedal before moving
the selector lever. If you attempt to move the
selector lever before depressing the brake
pedal, the selector lever may become
immovable.
When the selector lever cannot be
shifted from the “P” (PARK) posi-
tion
BK0239700US.book 69 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
