EasyManua.ls Logo

Mitsubishi Outlander 2017 - Page 193

Mitsubishi Outlander 2017
521 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Adaptive Cruise Control System (ACC) (if so equipped)
5-112 Features and controls
5
N00581500027
There are two ways to increase the set speed.
The set speed will increase by 1 mph (1
km/h) every time you push up the “RES +”
switch while the ACC is activated. If you
hold the switch pushed up, the set speed
increases in 5 mph (5 km/h) increments.
When the height of a vehicle in front is
extremely low or the road clearance of
the vehicle is extremely high.
When driving on a road with alternating
up and down surfaces.
When driving on a curve.
When driving on a bumpy or rough road.
When driving in a tunnel.
When driving in construction zones.
When the rear of your vehicle is weighed
down with the weight of passengers and
luggage
For up to two minutes after starting driv-
ing.
When driving in curved sections of road
including their entrance/outlet or run-
ning beside a closed lane in a traffic work
or similar zone.
When the surface of the sensor is covered
with dirt, snow, ice, etc.
When a front vehicle or an oncoming
vehicle is splashing water, snow or dirt.
WARNING
When driving on a winding road.
Never use the ACC in the following situa-
tions:
In heavy traffic.
On winding roads.
On slippery roads, such as icy, snow-cov-
ered or dirt roads.
In adverse weather conditions, such as
rain, snow or sand storms, etc.
On steep downslopes.
When the inclination of a road fre-
quently changes.
When the approach alarm frequently
sounds.
When your vehicle is towed or is towing
another vehicle.
When your vehicle is on a chassis dyna-
mometer or free rollers.
When tire inflation pressures are not
adequate.
When the temporary spare tire is being
used.
When the radar sensor and/or its sur-
rounding area are damaged or deformed.
WARNING
CAUTION
To maintain proper performance of the ACC:
Always clean the surface of the radar sen-
sor.
Avoid impacting the radar sensor or its sur-
rounding area.
Do not put a sticker on the radar sensor or
its surrounding area.
Do not paint the radar sensor.
Do not install a grill guard.
Do not modify the radar sensor or its sur-
rounding area.
Always use tires of the same size, same
type, and same brand, and which have no
significant wear differences.
Do not modify the vehicle’s suspension.
To increase the set speed
By using the “RES +” switch:
BK0239700US.book 112 ージ 2016年6月16日 木曜日 午前10時58

Table of Contents

Related product manuals