Forward Collision Mitigation System (FCM) (if so equipped)
5-122 Features and controls
N00577800061
This switch is used to turn on or off the FCM
and Ultrasonic misacceleration Mitigation
System, and also to select the distance which
will trigger the forward collision warning
function.
Every time the operation mode is put in
“ON”, the FCM and Ultrasonic misaccelera-
tion Mitigation System will automatically be
turned on.
To turn off the FCM and Ultrasonic misaccel-
eration Mitigation System, press and hold the
FCM and Ultrasonic misacceleration Mitiga-
tion System switch. The following message
and indicator will appear in the multi-
information display.
To turn on the FCM and Ultrasonic misaccel-
eration Mitigation System again, press and
hold the FCM and Ultrasonic misacceleration
Mitigation System switch. The indicator
will go off, and a current distance mode for
the forward collision warning will be shown
in the multi-information display.
The distance to the vehicle ahead which trig-
gers the forward collision warnings can be
selected from three levels, “FAR”, “MID-
DLE” or “NEAR”.
FCM and Ultrasonic misaccel-
eration Mitigation System
ON/OFF switch
To turn on/off the FCM and Ultra-
sonic misacceleration Mitigation
System
When the FCM and Ultrasonic misaccelera-
tion Mitigation System ON/OFF switch is
held pressed to change the ON/OFF state of
the FCM, the ON/OFF state of the Ultrasonic
misacceleration Mitigation System is also
changed at the same time.
The indicator is combined with the
“Ultrasonic misacceleration Mitigation Sys-
tem OFF” indicator.
To change forward collision warn-
ing distance
BK0239700US.book 122 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
