Rear Cross Traffic Alert (RCTA) (if so equipped)
5-138 Features and controls
1. Press the Blind Spot Warning switch
while the operation mode is put in ON.
(Refer to “Blind Spot Warning (BSW): To
operate” on page 5-134.)
2. When the selector lever is moved to the
“R” (REVERSE) position, the RCTA will
operate.
If the system detects a problem, a warning is
displayed on the information screen in the
multi-information display.
Refer to “Blind Spot Warning (BSW): Sys-
tem problem warning” on page 5-134.
N00594000026
For vehicles sold in U.S.A
FCC ID:OAYSRR3A
For vehicles sold in Canada
Applicable law: Canada 310
Frequency bands: 24.05 - 24.25GHz
Output power: less than 20 milliwatts
This device complies with Part 15 of FCC
Rules and Industry Canada licence-exempt
RSS standard(s).
Operation is subject to the following two con-
ditions:
This device may not cause harmful inter-
ference.
This device must accept any interference
received, including interference that may
cause undesired operation.
To operate
Set the RCTA to OFF when towing.
The Blind Spot Warning light in the outside
rearview mirror may not look due to strong
direct sunlight or the glare from the head-
lights of vehicles behind you during night
driving.
When a problem is detected in
the system
General information
Changes or modifications not expressly
approved by the manufacturer for compli-
ance could void the user’s authority to oper-
ate the equipment.
BK0239700US.book 138 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
