Mitsubishi Outlander 2017 - Page 221

Lane Departure Warning System (LDW) (if so equipped)
5-140 Features and controls
5
N00581100036
The LDW, when turned ON, is capable of
recognizing the lane in which your vehicle is
travelling and issuing an audible warning
when your vehicle begins to leave that travel
lane. When operating, the “LDW” indicator
on the multi-information display will be
changed to indicator (green). The LDW
will not operate, however, and the “LDW”
indicator will be appeared if any of following
conditions have occurred:
 The vehicle speed is less than 38 mph (60
km/h).
 The turn signal lever is being operated or
has been operated in the past 7 seconds.
 The hazard warning light is being oper-
ated or has been operated in the past 7
seconds.
N00581200040
While the “LDW” indicator in the informa-
tion display is lit in green, if your vehicle is
leaving or has left the lane, a buzzer will
sound intermittently, “LANE DEPARTURE”
will appear in the information display and
the indicator will be flashing in amber.
NOTE
 When you set the operation mode to “OFF”
with the system “OFF,” the system will be
restored “ON.” (“LDW 1” mode)
You can also select the “LDW 2” mode
which makes always the LDW system in
‘OFF state’.
1. Press the LDW switch, and the system is
placed in the ‘OFF state’.
2. Press and hold the LDW switch for more
than approximately 10 seconds. The
“LDW 2” indicator appears on the multi
information display.
3. Press the LDW switch, and the “LDW”
indicator on the top-right of the multi
information display goes out.
To return to the “LDW 1” mode, put the sys-
tem in ‘OFF state’, press and hold the LDW
switch for more than approximately 10 sec-
onds. The “LDW 1” indicator appears on the
multi information display.
Operation of the LDW
Lane departure warning
NOTE
 The warnings will not continue for more than
3 seconds, even if your vehicle continues
leaving the lane.
 If the lane markers are only on one side of
the road, the LDW will operate only for the
appropriate side where the lane marker is
drawn.
WARNING
 The LDW will not function when no lane
marker exists, such as at an intersection
or near a toll booth.
 The LDW may not operate correctly in the
following situations and the LDW may not
give warnings or may give false warnings:
• When lane markers are not clearly visi-
ble due to rain, snow, fog, dark area, etc.
• When the road surface is shiny.
• When old lane markers remain on the
road surface.
• When the lane markers are double lines
or the shape of the lane markers are
complicated.
• When driving in an extremely narrow
lane.
• When the distance between your vehicle
and a vehicle in front is short.
• When driving into the sun light.
• When driving on curves.
• When driving on bumpy roads.
• When driving in construction zones.
BK0239700US.book 140 ページ ２０１６年６月１６日 木曜日 午前１０時５８分