Tire pressure monitoring system
5-146 Features and controls
N00584300026
In case that 2 sets of tire inflation pressure
sensor ID are registered in the receiver, the
valid tire ID set can be changed by following
procedure.
[For vehicles equipped with color liquid crys-
tal display meter]
1. Operate the multi information display
switch to switch the information screen to
the menu screen.
Refer to “Multi information display
switch” on page 5-167.
Refer to “Changing the function settings”
on page 5-177.
2. Lightly press the multi information dis-
play switch to select “ ” (tire
ID set change).
3. Hold down the multi information display
switch for about 3 seconds or more. The
setting changes to the selected tire ID set.
4. The valid tire ID set is changed, and the
number of the tire pressure monitoring
system (TPMS) SET indicator is changed.
[For vehicles equipped with mono-color liq-
uid crystal display meter]
1. Transit the display by multi information
display switch until the tire pressure mon-
itoring system (TPMS) SET indicator is
displayed.
2. Hold down the multi information display
switch for 10 seconds or more. (A beep is
heard.)
(Although the reset execution starts at
holding down the switch for 3 seconds,
keep holding down the switch continu-
ously.)
3. The valid tire ID set is changed, and the
number of the tire pressure monitoring
system (TPMS) SET indicator is changed.
The use of non-genuine wheels will prevent
the proper fit of the tire inflation pressure
sensors, resulting air leakage or damage of
the sensors.
Tire ID set change
Each time this procedure is done, the tire ID
set is changed. (1 - 2 - 1 - 2 …)
The tire ID set is NOT changed, in case that
only 1 set of ID is registered.
Each time this procedure is done, the tire ID
set is changed. (1 - 2 - 1 - 2 …)
The tire ID set is NOT changed, in case that
only 1 set of ID is registered.
BK0239700US.book 146 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
