Rear-view camera (if so equipped)
5-152 Features and controls
When the selector lever is shifted out of the
“R” (REVERSE) position, the rear-view
image will go off.
The rear-view camera (A) is in the liftgate, at
the left side of the liftgate handle.
Reference lines and upper surface of the rear
bumper (A) are displayed on the screen.
Red line (B) indicates approximately 20
inches (50 cm) behind the rear bumper.
Two Green lines (C) indicate approxi-
mately 8 inches (20 cm) outside of the
vehicle body.
Short transverse lines (1 to 3) indicate dis-
tance from the rear bumper.
Never rely solely on the rear-view camera
to clear the area behind your vehicle.
Always check visually behind and all
around your vehicle for persons, animals,
obstructions or other vehicles. Failure to
do so can result in vehicle damage, serious
injury or death.
The rear-view camera is an aid system for
backing up, but it is not a substitute for
your visual confirmation.
The view on the screen is limited, and
objects outside the view, such as under the
bumper or around either corner of the
bumper end, cannot be seen on the screen.
Location of rear-view camera
If the camera lens gets dirty, a clear image
cannot be obtained. As necessary, rinse the
lens with clean water and gently wipe with a
clean, soft cloth.
To avoid damaging the camera;
• Do not rub the cover excessively or polish
it by using an abrasive compound.
• Do not disassemble the camera.
• Do not splash hot water directly on the lens.
• Do not spray the camera and its surround-
ings with high-pressure water.
• Make sure that the liftgate is securely
closed when backing up.
Reference lines on the screen
1: Approximately at the rear edge of the
rear bumper
2: Approximately 39 inches (100 cm)
3: Approximately 79 inches (200 cm)
BK0239700US.book 152 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
