Mitsubishi Outlander 2017 - Page 262

Multi Information display - Type 1
Features and controls 5-181
5
N00529801328
The language used in Mitsubishi Multi-Com-
munication System (if so equipped), Blue-
tooth
®
2.0 interface or Multi Around Monitor
(if so equipped) can be changed automatically
to the same language as that shown in the
multi information display.
1. Press and hold the multi information dis-
play switch (for about 2 seconds or more)
to switch from the setting mode screen to
the menu screen. Refer to “Changing the
function settings” on page 5-177.
2. Lightly press the multi information dis-
play switch to select “ ” (language
cooperative control).
3. Press and hold the multi information dis-
play switch to switch from A/1 (language
cooperation: enabled) to M/2/P (language
cooperation: disabled), or from M/2/P to
A/1. The setting is changed to the selected
condition.
N00557401156
You can turn off the operation sounds of the
multi information display switch and rheostat
illumination button.
1. Press and hold the multi information dis-
play switch (for about 2 seconds or more)
to switch from the setting mode screen to
the menu screen.
Refer to “Changing the function settings”
on page 5-177.
2. Lightly press the multi information dis-
play switch to select “ ” (operation
sound setting).
3. Press and hold the multi information dis-
play switch (for about 2 seconds or more)
to switch from ON (operation sound on)
to OFF (operation sound off), or from
OFF to ON.
The setting is changed to the selected con-
dition.
Changing the language on other
system to match the multi infor-
mation display
NOTE
 If the battery is disconnected, the language
cooperative control is automatically set to
“A or 1” (language cooperation: enabled).
 The language cooperation setting can be
switched in the following manner.
• When “A or 1” (language cooperation:
enabled) has been selected, the language for
Mitsubishi Multi-Communication System
(if so equipped), Bluetooth
®
2.0 interface
or Multi Around Monitor (if so equipped) is
automatically changed to the language
selected for the multi information display.
However, this changing function may not
work depending on the language selected
for the multi information display.
• When “M, 2 or P” (language cooperation:
disabled) has been selected, the language
for Mitsubishi Multi-Communication Sys-
tem (if so equipped), Bluetooth
®
2.0 inter-
face or Multi Around Monitor (if so
equipped) is not automatically changed to
match the language selected for the multi
information display.
 The language on the audio system’s display
does not automatically change when you
select A or 1 (language cooperation:
enabled) in the language cooperation control.
Operation sound setting
NOTE
BK0239700US.book 181 ページ ２０１６年６月１６日 木曜日 午前１０時５８分