Wiper and washer switch
Features and controls 5-233
With the lever in the “INT” (speed sensitive
intermittent operation) position, the intermit-
tent intervals can be adjusted by turning the
knob (A).
The misting function can be used when the
ignition switch or the operation mode is in
ON or ACC.
The wipers will operate once if the wiper
lever is raised to the “MIST” position and
released. This operation is useful when it is
drizzling, etc. The wipers will continue to
operate while the lever is held in the “MIST”
position.
The windshield wipers can be operated with
the ignition switch or the operation mode is in
ON or ACC.
If the blades are frozen to the windshield or
rear window, do not operate the wipers until
the ice has melted and the blades are freed,
otherwise the wiper motor may be damaged.
To adjust intermittent intervals
1- Fast
2- Slow
The speed-sensitive-operation function of
the windshield wipers can be deactivated.
For further information, please contact your
authorized Mitsubishi Motors dealer or a
repair facility of your choice. On vehicles
equipped with Mitsubishi Multi-Communi-
cation System, screen operations can be used
to make the adjustment.
Refer to separate owner’s manual for details.
Misting function
Vehicle with rain sensor
MIST- Misting function
The wipers will operate once.
OFF- Off
AUTO- Auto-wiper control
Rain sensor
The wipers will automatically
operate depending on the degree of
wetness on the windshield.
LO- Slow
HI- Fast
BK0239700US.book 233 ページ ２０１６年６月１６日 木曜日 午前１０時５８分
To Next Page
Loading...
