Mitsubishi Outlander 2017 - Page 328

Bluetooth® 2.0 interface
Features and controls 5-247
5
4. When enrollment is “enabled,” the voice
model is on; when enrollment is “dis-
abled,” the voice model is off. Say the
command that fits your needs.
Say “Retrain” to start the speaker enroll-
ment process and recreate a new voice
model. (Refer to “Speaker enrollment” on
page 5-245.)
N00565001395
Before you can make or receive hands-free
calls or play music using the Bluetooth
®
2.0
interface function, you must pair the Blue-
tooth
®
device and Bluetooth
®
2.0 interface.
Up to 7 Bluetooth
®
devices can be paired
with the Bluetooth
®
2.0 interface.
If multiple paired Bluetooth
®
devices are
available in the vehicle, the cellular phone or
music player most recently connected is auto-
matically connected to the Bluetooth
®
2.0
interface.
You can also change a Bluetooth
®
device to
be connected.
To pair a Bluetooth
®
device with the Blue-
tooth
®
2.0 interface, use either one of the fol-
lowing 2 methods (Type 1 or Type 2).
1. Stop your vehicle in a safe area, put the
selector lever in the “P” (PARK) position
and apply the parking brake.
2. Press the SPEECH button (except for
vehicles with Mitsubishi Multi-Commu-
nication System) or PICK-UP button (for
vehicles with Mitsubishi Multi-Commu-
nication System).
3. Say “Setup.”
4. Say “Pairing Options.”
5. The voice guide will say “Select one of
the following: pair, edit, delete, or list.”
Say “Pair.”
6. The voice guide will say “Please say a 4-
digit pairing code.” Say a 4-digit number.
When the confirmation function is on, the
system will confirm whether the number
said is acceptable. Answer “Yes.”
Answer “No” to return to pairing code
selection.
Connecting the Bluetooth
®
2.0
interface and Bluetooth
®
device
NOTE
 Pairing is required only when the device is
used for the first time. Once the device has
been paired with the Bluetooth
®
2.0 inter-
face, all you need is to bring the device into
the vehicle next time and the device will
connect to the Bluetooth
®
2.0 interface auto-
matically (if supported by the device). The
device must have Bluetooth
®
turned ON to
connect.
To p air
 Pairing procedure- Type 1 (if so
equipped)
NOTE
 You cannot pair any Bluetooth
®
device with
the Bluetooth
®
2.0 interface unless the vehi-
cle is parked. Before pairing a Bluetooth
®
device with the Bluetooth
®
2.0 interface,
confirm that the vehicle is parked in a safe
location.
NOTE
 If 7 devices have already been paired, the
voice guide will say “Maximum devices
paired” and then the system will end the
pairing process. To register a new device,
delete one device and then repeat the pairing
process.
(Refer to “Selecting a device: Deleting a
device” on page 5-251.)
BK0239700US.book 247 ページ ２０１６年６月１６日 木曜日 午前１０時５８分