Mitsubishi Outlander 2017 - Page 393

Dual-zone automatic climate control air conditioner
7-10 Comfort controls
7
• When the setting has changed from
enabled to disabled, the system will beep
three times and the indicator light will
flash three times.
• When the setting has changed from dis-
abled to enabled, the system will beep
two times and the indicator light will
flash three times.
On vehicles equipped with Mitsubishi
Multi-Communication System, screen
operations can also be used to change the
setting. Refer to the separate owner’s
manual for details.
N00737301467
Push the switch, and the air conditioning
compressor will turn on. The “ ” indicator
will be shown in the display (A).
Push the switch again and the air condition-
ing compressor will stop and the indicator
goes off.
N00712200022
You can change the following functions to
match your preference.
 Enable automatic air conditioning control:
When the AUTO switch is pressed, or
when the temperature control switch has
been set to the minimum temperature, the
air conditioning switch is automatically
controlled.
 Disable automatic air conditioning con-
trol:
The air conditioning switch is not auto-
matically controlled, unless the air condi-
tioning switch is used.
 Changing the settings
Press the air conditioning switch for about
10 seconds or longer.
When the setting has changed, the system
will beep and the indicator light will flash.
• When the setting has changed from
enabled to disabled, the system will beep
three times and the indicator light will
flash three times.
• When the setting has changed from dis-
abled to enabled, the system will beep
two times and the indicator light will
flash three times.
NOTE
 The factory setting is “Enable automatic air
selection control”.
 When the defogger switch is pressed, the air
selection will automatically change to the
outside air position, even if the system is set
to “Disable automatic air selection control”,
in order to prevent windows from fogging
up.
Air conditioning switch
NOTE
 If a problem is detected in the air condition-
ing compressor, the “ ” indicator blinks.
Press the air conditioning switch once to turn
it off, then once more to turn it back on. If
the“ ” indicator does not blink, there is no
problem. If it does blink, have it checked at
an authorized Mitsubishi Motors dealer or a
repair facility of your choice.
 For example, sometimes after using a high-
pressure car wash, the condenser can get wet,
and the “ ” indicator blinks temporarily.
Wait for a while, press the air conditioning
switch once to turn the system off, then once
more to turn it back on. Once the water evap-
orates, the blinking will stop.
 Personalizing the air conditioning
switch (Changing the function set-
ting)
BK0239700US.book 10 ページ ２０１６年６月１６日 木曜日 午前１０時５８分